When the Status light flashes Green/Red for 5 seconds, this indicates that the Gyro needs calibration. Turn Presenter off and, holding the Previous Slide key, turn it back on. The Status Light will slowly flash Green/Red for 10 seconds while Presenter is calibrating, then turn solid Green for 3 seconds, indicating a successful recalibration of Presenter’s gyroscope.
Search Results for:
How do I pair the USB receiver to the handset?
The Handset is paired with the USB receiver at the factory prior to shipping. Should re-pairing become necessary, plug the Presenter UHF Receiver Dongle into an available USB port on your computer, press and hold the CONNECT button on the handset for 3 seconds. The Status light will alternatively flash Green & Red until paired: or will go off after 1 minute if pairing has failed.
What does Presenter’s “Status” light indicate?
- Power on – The Status light will turn Green for 3 seconds, then turn off.
- Pairing Mode – The Status light will alternatively flash Green & Red until paired: or will go off after 1 minute if pairing has failed. Pairing must be initiated (by pressing the connect button on the handset) within 1 minute of plugging the USB receiver into your system.
- Pairing Success – The Status light will flash 3 times, then turn off when pairing is successful.
- Low Battery – Low battery warning will be indicated by slow Red flash every 3 seconds, until the power is drained out or the power turned off.
- Laser On / Warning – While the laser button is pressed and the laser is on, the Status light will light up Green.
- Gyro Calibration – The Status light will alternatively flash Green & Red for 5 seconds to indicate that the Gyro is in need of calibration.
Can I use the Air Mouse Presenter with my Unix or Linux system?
Unfortunately not. The Air Mouse Prsenter is designed and supported to work on PC Windows (Windows XP and above) and on Apple Mac (OS X Snow Leopard and above) systems only.
Does the Air Mouse Presenter to work on a Mac?
The Air Mouse Presenter is designed and supported to work on PC Windows (Windows XP and above) and on Apple Mac (OS X Snow Leopard and above) systems.
How do I install my Air Mouse Presenter?
Installing the Air Mouse Presenter is a snap. Just follow the instructions in the Quick Start Guide shipped with your mouse
My Air Mouse Voice is depleting its battery at a rapid rate.
As a Bluetooth device, your Air Mouse Voice is always ON, even when you’re not using it. Be sure to switch the mouse OFF after using to conserve battery life.
How do I trouble-shoot my Air Mouse Voice installation?
Just follow the instructions shipped with your mouse:
- Confirm that your system is running a 64-bit version of Windows or OS X and that it supports Bluetooth 4.0 LE connectivity
- Check that your mouse batteries installed correctly and fully charged
- Confirm that your mouse ON/OFF switch (on underside of mouse) is set to ON
- Check that your MotionTools 3 software in installed and active
My cursor is drifting when using Air Mouse Voice in the air. How can I fix this?
The ‘in air’ operation of your Air Mouse Voice was calibrated during manufacture. If you find that your cursor is drifting, you can easily recalibrate it following these simple steps:
- Power off Air Mouse Voice (ON/OFF switch on underside)
- Holding the Trigger Button (underside of mouse), power the mouse back on.
- Now, set Air Mouse Voice down on a flat surface.
- After 5-10 seconds, the Air Mouse LED will blink 4 times, indicating a successful recalibration.
Do I need Bluetooth 4.0 LE to use Air Mouse Voice?
Yes. If you’re using an older system that offers Bluetooth, but not necessarily Bluetooth 4.0 Low Energy, connectivity you may need to purchase an after-market Bluetooth 4 Low Energy receiver dongle to connect to Air Mouse Voice.